China Metal powder injection parts for car doors Manufacturers Factory Suppliers

Metal Injection Molding Auto Parts

Compared with traditional machining methods, MIM technology has the characteristics of high precision, high strength, high shape complexity, material diversity, and low cost, so Metal Injection...

Nebulizer Housings MIM Parts

In the 3C industry, MIM has become synonymous with the metal protection frame of the iPhone's mobile phone card tray and camera ring. However, in addition to these, precision accessories in...

Automotive Rocker MIM Parts

The rocker arm in a car is actually a double-arm lever used to redirect the force from the push rod to act on the end of the valve rod to push the valve open. The ratio of the arm lengths on both...

Breaking Pliers Tips MIM Parts

The basic process steps of metal injection molding are: first, select the metal powder and binder that meet the requirements of MIM, and then use an appropriate method to mix the powder and binder...

Metal Powder Injection Molded Parts For Electronic Locks

There is a sufficient amount of chromium in the iron-based alloy to form a stable passivation film on the surface. Iron-based alloys with a chromium content of more than 10.5% can be called...

5G Optical Communication Base MIM Parts

The metal injection molding process has gradually been recognized, accepted and valued by people. In order to meet the production needs of more complex parts, the latest technologies in many...

Ultrasonic Knife Forceps MIM Parts

Inner and outer core tubes: In terms of inner and outer diameter tolerances and length runout, strict control is required. The concentricity of all steps is also very important (tolerance...

SMH-2-B(Q)6-5TR Computer Pattern Machine Rotary Bobbin Case

Adjusting the shuttle bed is actually adjusting the best position of the upper shaft and the lower shaft. In principle, the bottom thread can only be brought up after the thread loop is formed....

6-7TR(D) Rotary Bobbin Case For Computer Pattern Machine

When the machine needs to sew thin sewing materials, the distance between the tip of the hook and the center of the needle should be adjusted to 8-12 mm. Turning an angle clockwise increases the...

Special-shaped Structural Parts MIM Parts

The roof is the structural part of the vehicle, because the roof is part of the vehicle frame. The structural part of the vehicle refers to the body frame, which can be simply understood as the...

Nail Clipper Metal Powder Injection Molded Parts

Nail clipper is one of the indispensable daily necessities in people's life, and it occupies a very important position in life. Most of the traditional nail clippers are made of ordinary alloy...

Cobalt Alloy Powder Injection Molding

Tungsten-cobalt alloy is also called tungsten carbide-cobalt carbide. According to the cobalt content, it can be divided into three categories: high cobalt (20% to 30%), medium cobalt (10% to 15%)...