-
SMH-6-5TR(H) Computerized Quilting Machine Thin Material ...
The adjustment of the hook and needle of the quilting machine is a very important process. This process affects the quality of the quilting. The quilting machine that is not adjusted in place may...
-
SMH-2-B(Q)6-5TR Computer Pattern Machine Rotary Bobbin Case
Adjusting the shuttle bed is actually adjusting the best position of the upper shaft and the lower shaft. In principle, the bottom thread can only be brought up after the thread loop is formed....
-
SMH-2-B(Q)6-5TR Synchronized Bobbin Case
The shuttle has a simple structure and low cost, but has a warp inertia force, which will cause wear on both ends of the shuttle carriage on the shuttle bed guide rail and on the shuttle itself....
-
SMH-2-ATR1Q(6-7TR) Synchronized Bobbin Case
The lockstitch machine has been running at high speed for a long time. When the speed is 4000 rpm, the rotary hook speed is 8000 rpm. Many domestic rotary hooks cannot reach this speed. If the...
-
SMH-1.6(MTQ) Computerized Embroidery Machine Rotary Shuttle
The shuttle is the main part of the canvas sewing machine. The bobbin case and the shuttle latch are connected to the shuttle body by the bobbin and the shuttle latch respectively. The bobbin case...
-
It is generally stipulated that a lockstitch machine or a computer lockstitch machine has three screws for fixing the hook. Loosening it can adjust the position of the hook and the straight...
-
6-7TR(D) Rotary Bobbin Case For Computer Pattern Machine
When the machine needs to sew thin sewing materials, the distance between the tip of the hook and the center of the needle should be adjusted to 8-12 mm. Turning an angle clockwise increases the...
-
With the increasing popularity of smart locks year after year, many users have installed smart locks in their homes, and a survey of smart lock users found that a large part of the reason why they...
-
Special-shaped Structural Parts MIM Parts
The roof is the structural part of the vehicle, because the roof is part of the vehicle frame. The structural part of the vehicle refers to the body frame, which can be simply understood as the...
-
Hardware Tools Metal Powder Injection Molding Parts
Metal powder injection molding (MIM) process is a new manufacturing process technology that combines traditional powder metallurgy process, powder ceramic process and plastic injection molding...
-
Grip Metal Powder Injection Molded Parts
In the fitness circle, the mainstream sports products have never been inconspicuous small equipment such as grips and wrist balls. Although they have been ignored, on the contrary, these sports...
-
Iron-based High Hardness MIM Parts
GH2036 is Fe-Cr-Ni-based precipitation hardening deformed superalloy, which mainly forms VC strengthening phase for precipitation hardening, and the service temperature is less than 650 ℃. The...
