Forklift Connecting Plate Lost Wax Investment Casting

Product Introduction

Forklift Connection Plate
The original meaning of textile is taken from the general term of spinning and weaving. However, with the continuous development and improvement of the textile knowledge system and subject system, especially the emergence of non-woven textile materials and three-dimensional composite weaving and other technologies, it is no longer just traditional hand spinning. and weaving, including non-woven technology and modern three-dimensional weaving technology. In order to facilitate the transportation of textile finished products, forklifts are mostly used for transportation. However, the fork tines of the forklift can easily be bent by the goods under long-term use, affecting the goods. The balance of transportation, and the goods are easy to shake when they are on the fork tines of the forklift. There is no fastening structure on the forklift connecting plate, which affects the efficiency of goods transportation.
In order to solve the problem that the fork tines of the forklift proposed above are easily bent by the goods under long-term use, which affects the balance of cargo transportation, and the goods are easy to shake when they are on the fork tines of the forklift, there is no fastening on the forklift connecting plate. The structure affects the efficiency of cargo transportation and technical issues. The purpose of this utility model is to provide a forklift connecting plate lost wax investment casting for the textile industry. The following technical solution is adopted: a forklift connecting plate for the textile industry, include:
The connecting plate has connection ports on the left and right sides of the front end of the connecting plate, and welding plates are welded on the left and right sides of the rear end of the connecting plate. A bracket is welded on the rear end of the welding plate, and a stop block is fixedly connected to the end of the bracket. There are reserved slots on both left and right sides of the connecting plate;
Spring shafts, the number of the spring shafts is consistent with the number of reserved slots, and the spring shafts are vertically embedded in the reserved slots. A nylon belt is wound around the middle of the spring shaft, and a pull block is provided at the head end of the nylon belt. , the head end of the nylon belt is embedded in the pull block, and the outer wall of the spring shaft is sleeved with a turntable above the nylon belt. The outer wall of the turntable is evenly provided with several sockets around it.
Preferably, a connecting piece is welded to the middle of the top end of the connecting plate, and the welding plate is located directly behind the connecting port, and the front face of the resisting block and the front face of the connecting plate are located on the same horizontal plane.
Preferably, the reserved groove is opened to the outer wall of the connecting plate, and the nylon belt extends to the outside of the connecting plate, the height of the pulling block is greater than the height of the reserved groove, and the pulling block is in contact with the reserved groove, and the nylon The end of the belt is embedded in the spring shaft.
Preferably, there are openings on the left and right sides of the back of the connecting plate, and the openings and the reserved grooves are interconnected. The openings are located directly behind the turntable, and both the nylon belt and the turntable rotate through spring shafts.
Preferably, the socket corresponds to the opening, and a plug is inserted between the socket and the opening.
 

Detection Systems

Copper Silica Sol Investment Casting