AП33 Powder Metallurgy Pressed Parts

Reinforced concrete slab PA 33-6 is designed for the installation of protective fences on the roofs of residential buildings without limitation of floors. The product is made by our company's powder metallurgy process

Send Inquiry

Product Introduction

AП33 powder metallurgy pressed parts
Item	Material	Production Process		Sintering Temperature		Mold	Custom
AП33 powder metallurgy	AП33	Powder metallurgy pressing		780℃		To be customized	Yes
Chemical composition	Si:0.40-0.8 Fe::0.7 Cu:0.15-0.40 Mn:0.15 Mg:0.8-1.2 Cr:0.04-0.35 Zn:0.25 Ti:0.15 Al: Balance Others: Individual: 0.05 Total: 0.15
Available Materials	Low carbon stainless steel, titanium alloy (Ti, TC4), copper alloy, tungsten alloy, hard alloy, high temperature alloy (718, 713)
Smoothness	Dimensional accuracy		Product density		Appearance treatment			Appropriate weight
Roughness 1～5μm	(±0.1%～±0.5%)		7.3-7.6g/CM³		According to customer requirements			0.03g～400g)

Product manufacturing standard: 1.138-2 series

1. Mark selection

Parabolic AP 33-6 plates in the 1.138-2 series are marked by the manufacturer according to internal guidance documents but must use the mandatory set of numbers and letters specified in this series.

① AP 33-4;

② AP 33-5;

③AP 33-6.

2. Main scope of application

Wainscoting 33-6 is suitable for duty class II buildings with a minimum temperature of -40°C (determined in accordance with SNI 2.01.01.82). This element is not a load-bearing element, so there are no other restrictions. For use at temperatures lower than specified, additional frost resistance requirements for the concrete must be documented.

3. Product marking

Label for 1.138-2 series AP 33-6 guardrail panels

Metal Injection Molding Process

product-800-600

Detection Systems

1661141928831

1661509092764001