Motorcycle Exhaust Flange Lost Wax Castings

Product Introduction

How to install the flange ring of the motorcycle exhaust pipe

Remove the exhaust pipe, clean the cylinder head interface, and install the muffler gasket into the cylinder head exhaust port.

If the gasket is too loose to fit, you can put a little butter or sealant on the gasket to hold it in place before installing the exhaust.

How to remove motorcycle exhaust pipe

First set up the double stand of the motorcycle, use the T-shaped No. 10 set of copper counterclockwise to remove the two No. 10 nuts at the exhaust pipe port, and then use No. 13 (scooter) and No. 17 (men's car) to disassemble. The rear fixing screw of the exhaust pipe is at the flat fork position. Just take off the exhaust pipe.

Note: When installing it back, check whether the exhaust pipe gasket is good or not and whether it needs to be replaced.

How to put the exhaust pipe mat of the three-wheeled motorcycle?

The installation method and steps of the three-wheeled motorcycle exhaust pipe mat: First, buy a piece of exhaust pipe mat of the same model as the three-wheeled motorcycle. When installing, first smear a little bit of butter (butter) on the exhaust port of the engine cylinder head (at the opening where the exhaust pipe is installed), and then place the center of the exhaust pad on it. (Because the butter has viscosity, the exhaust pad will not fall off) Finally, install the exhaust pipe and tighten it.

How to install motorcycle exhaust pipe gasket?

There are special tools for fixing the motorcycle clutch. If there is no such tool, you can find a rag and insert it between the clutch gear and the crankshaft gear. Pay attention to the direction of rotation when screwing the screw, so that when the clutch screw is removed, the clutch big gear and the crankshaft gear just get stuck with the rag pinch without damaging the gear or other components, so the clutch retaining nut can be removed.

Motorcycle exhaust pipe mat installation

Most of them are asbestos pads, which are not expensive. Just buy a new one and replace it. If there is no pad, there will be a sound of porcelain air leakage, and the air outlet will be blackened by carbon deposits.

How to install the mat of the motorcycle exhaust pipe?

Insert the key into the keyhole under the motorcycle mat, and turn it to the left to open it.

Motorcycle exhaust interface pad installation

To disassemble the valve of a motorcycle, you need to remove the carburetor, exhaust pipe, cylinder head, and other components first, then use a special tool or a pipe with a suitable diameter to cushion the upper cover of the valve spring, and knock it with a hammer to remove it. Lower the valve lock clip, and then pull out the valve. Since there are many parts that need to be disassembled, and some tools and necessary maintenance knowledge are required, do not disassemble it yourself if you are not a repairman.

Motorcycle exhaust pipe mat installation

The exhaust pipe gasket will be washed out, the exhaust pipe will also be damaged, and the cylinder gasket will also be washed out

How to install the motorcycle exhaust pipe interface pad?

Yes, motorcycle exhaust pipe asbestos gaskets and asbestos rubber gaskets are made of asbestos fibers and rubber as the main raw materials, supplemented with rubber compounding agents and fillers, and are made through mixing, hot roll molding, and vulcanization.

Asbestos rubber gaskets can be divided into ordinary asbestos rubber gaskets and oil-resistant asbestos rubber gaskets according to their formula, process performance, and application. According to the temperature and pressure used, it can be divided into low-pressure asbestos rubber gaskets, medium-pressure asbestos rubber gaskets, and high-pressure asbestos rubber gaskets.

Detection Systems

Copper Silica Sol Investment Casting