Lift Pinion Lost Wax Castings

Product Introduction

The lift is a device used for lifting the car in the process of car maintenance. When the car is driven to the lift station, the car can be lifted to a certain height through manual operation, which is convenient for car maintenance. Lifts play a very important role in car repair and maintenance, and now repair shops are equipped with lifts, which are essential equipment for car repair shops.

Operating procedures

1. Before using Lift Pinion Lost Wax Castings, remove the appliances and sundries near the lift that hinder the operation, and check whether the operating handle is normal.

2. The operating mechanism is sensitive and effective, and the hydraulic system does not allow crawling.

3. When supporting the vehicle, the four supporting angles should be on the same plane, and adjust the height of the rubber pads of the supporting angles to make them contact the supporting parts of the vehicle chassis.

4. When supporting the vehicle, the vehicle cannot be supported too high, and the four brackets must be locked after being supported.

5. After the lifted vehicle enters, the lift support block should be adjusted and moved to align with the specified lifting point of the vehicle.

6. When lifting, personnel should leave the vehicle. When lifting to the required height, the safety lock pin must be inserted, and the bottom work can only be started after ensuring safety and reliability.

7. Except for subsistence allowances and minor repair items, other cumbersome and cumbersome operations are not allowed to be operated and repaired on the lift.

8. The lifter must not be lifted and lowered frequently.

9. When supporting the car, the lift must be steady and the landing must be slow.

10. It is strictly forbidden to raise or lower the lift when someone is working.

11. If the operating mechanism is found to be ineffective, the motor is not synchronous, the bracket is uneven or the hydraulic part leaks oil, it should be reported for repair in time, and it is not allowed to operate while sick.

12. After the operation, the sundries should be removed and the area around the lift should be cleaned to keep the site tidy.

13. Regularly (half a year) remove the water accumulated in the oil cylinder of the lift, and check the oil volume. If the oil volume is insufficient, the pressure oil of the same brand should be filled in time. At the same time, check lubrication, lift transmission gears and seams. The use of car lifts can be divided into four-wheel alignment type and flat type according to the function; it can be divided into the ground type and underground type according to the occupied space; the ground type does not need to dig grooves and is suitable for any repair shop. It is suitable for installing two-post lifts and ordinary four-post lifts, and the machine has a wide contact area with the floor, so it can be installed on any floor that can be driven to solve customer site problems. Compared with the two-post and four-post lifts, the biggest advantage of the scissor lift is that it does not take up space and is easy to use. The disadvantage is that the balance of oil replenishment is very strict, and it needs to be equipped with a control box, which is more expensive.

Detection Systems

Copper Silica Sol Investment Casting