
Rotor Ductile Iron Parts
According to ISO standards, the rotating body supported by the bearing is called the rotor. Rotors are the main rotating parts in power machinery and working machinery.
Product Introduction
|
Rotor ductile iron parts |
|||||||
|
Item |
Material |
Production Process |
Sintering Temperature |
Mold |
Custom |
||
|
Rotor ductile iron parts |
Nodular cast iron |
Investment casting |
1380℃ |
To be customized |
Yes |
||
|
Chemical composition |
Processing customization |
||||||
|
Available Materials |
Low carbon stainless steel, titanium alloy (Ti, TC4), copper alloy, tungsten alloy, cemented carbide, high temperature alloy (718, 713) |
||||||
|
Smoothness |
Dimensional accuracy |
Product density |
Appearance treatment |
Appropriate weight |
|||
|
Roughness 1~5μm |
(±0.1%~±0.5%) |
7.3-7.6g/CM³ |
According to customer requirements |
0.03g~40Kg |
|||
Introduction to terms
According to ISO standards, the rotating body supported by the bearing is called the rotor. Rotors are the main rotating parts in power machinery and working machinery.
The rotating part of an electric machine or certain rotating machines, such as turbines. The rotor of the motor is generally composed of an iron core with a coil, a slip ring, and a wind vane.
The main components of high-speed rotation in power machinery or working machinery, such as electric motors, generators, gas turbines and turbine compressors.
When the main rotor rotates at high speed, the deflection deformation occurs when its speed approaches the critical speed. Even mechanical damage due to resonance. The natural frequency of the transverse vibration of the rotor is multi-order, so the corresponding critical speed is also multi-order. When the working speed of the rotor is lower than the first order critical speed, it is called a rigid rotor, and when the working speed of the rotor is higher than the first order critical speed, it is called a flexible rotor.
The operating speed of any type of rotor must not be close to the critical speed. The critical speed of rotor depends on its manufacturing material, structural form, geometric size, supporting characteristics and other factors.
Working principle
For example, a rotor in an induction motor consisting of a rotating shaft core and a closed conductor embedded in the core produces a high-speed rotational motion driven by a rotating magnetic field generated by the stator windings. Both ends of the rotor adopt rolling bearings and are installed and fixed in the end cover of the motor housing.

Because no matter what type of rotor, when its operation will produce centrifugal inertia force, and affect the strength and mechanical efficiency of the rotor. Therefore, the rotor is properly balanced and the mass of each part is redistributed in order to reduce the centrifugal inertia force generated in the rotation process.
When the unbalanced mass of the rotor is approximately distributed in the same plane perpendicular to the axis of rotation, such as the balance of a single disc CAM, static balance can be achieved by increasing or removing the size and position of the weight of the balance block, even if the center of gravity of the mass of each part of the rotor overlaps with the axis of rotation.
When the unbalanced weight of the rotor is located in the parallel plane of the vertical rotation axis, only after the rotor rotates, the unbalanced weight will appear, and the elimination of this dynamic imbalance is mostly through changing the weight and position of the balance block, eliminating the inertial force and inertia couple to achieve dynamic balance. Avoid rotor vibration on the elastic support.
Detection Systems

Copper Silica Sol Investment Casting


We are the manufacturer of "Rotor ductile iron parts", if you need more information please contact us!
Send Inquiry









