How to apply the powder metallurgy motorcycle balance moving gear plate?

How to apply the powder metallurgy motorcycle balance moving gear plate?

With the development of the times, powder metallurgy has become an indispensable existence. Because of the appearance of powder metallurgy technology, our parts can be made reliably and complex, so how to apply the powder metallurgy motorcycle balance dynamic gear plate? The following is the share of zhongwei precision editor.

The balance driven gear disc of motorcycle engine is composed of driven gear jacket, driven gear disc, buffer sleeve, cover plate and rivet. The driven gear sleeve and driven gear plate are equipped with clearance assembly structure, which can effectively cushion the impact force of gear meshing, and greatly reduce the engine vibration and the meshing noise of the main and driven gears of the balance shaft.

Powder metallurgy gear has the following advantages:

1. The production cycle of 3000 pieces is 5 days, which is 40% shorter than the traditional process;

2. EMS intelligent monitoring and control system is adopted in the production process, with high consistency of product quality and greatly reduced unqualified rate (300PPM at present);

3. Beautiful and practical appearance;

4. The product quality is 10% higher than that produced by traditional technology;

5. After one year of mass production, the production cost is 15% lower than that of traditional process.

Technical index of powder metallurgy gear:

1. Tensile strength: 1100Mpa; Yield strength: 430Mpa;

2. Density

Rib plate and middle boss: more than 7.0g/cm3;

Claw density: more than 7.4g/cm3;

To sum up, relevant content is shared here. I hope this article can help you. If you need more information about powder metallurgy, please pay attention to the official website of zhongwei Precision.